|
CUSTOMER
TESTIMONIALS
Paul
Flynn
New London,
Connecticut
I installed the HyperVent material under the foam mattress on my 10 metre power boat to control condensation. It was
easy to cut, glue the 2 pieces together due to bunk width, and put into place. I had enough left over to cut a piece
to put under the helm seat which also had a condensation problem. The HyperVent did the trick in both situations and
I'm pleased with the product.
Bob McBride
Harrison,
Maine
We used HyperVent this year under the V berth on our 8.5 metre lobster cruising boat with great success
here in the rather cold waters of Maine. It allowed air to circulate under the cushions eliminating any moisture that
might have been looking for a home. I also used what was left over to line the bottoms of our below water line storage
lockers which kept the contents dry and free of mildew. HyperVent was very easy to install. My wife did most of the
cutting using a pair of workshop scissors. I am delighted that I "discovered" the product in the Sept/Oct 2000 issue
of PassageMaker and certainly recommend that others try it as a solution to their moisture problems.
Jim Ripple
Canton,
Ohio
I am very pleased
with HyperVent I ordered more than I needed for under the
mattresses and discovered many practical applications on the
boat. Two layers in the bottom of the refrigerator keeps foods
and beverages above any water accumulation (stripped the
backing off for this application). Lining settee storage
lockers solved a mold growth problem by eliminating
condensation on the hull. I even used scraps to line the
cradle for the mast during winter storage. And by the way, it
worked under the mattress; no more dampness. I'll be placing
another order this spring to line the aft lazarette and
under
settee cushions. Great product.
Marv Otto
Kenner,
Louisiana
So far, so good.
In our extremely humid climate (New Orleans) I have had no
under-mattress moisture since I have used your product.
Previously, I could count on it.
Lorraine & Andrew
Imperato
Sayville, NY
Dear Mr. Farnsworth,
Recently we purchased HyperVent from you. First, thank you for
sending it to us when you said you would - before you received
our check. Second, we are very happy with the way HyperVent is
working for us. We own a motorhome and we always have a wet
mattress. We have a compartment under our bed. So when it's
cold outside and warm inside, we have a problem. With
HyperVent under our mattress, it has solved our problem. We
tell many people who have RV's about you product.You may use
our comments. We found the product in the September 2002 issue
of Highways which is a R.V. magazine from Good Sam Club.
I'm very happy with the HyperVent in my vee berth. As you know, I ordered the product in August after seeing
your advertisement in Lats and Att. I've tried a number of different products in an attempt to deal with the condensation
and odor that results from sleeping on foam cushions in the vee berth of my 7.6 metre sailboat. As a liveaboard, I
am forced to deal with conditions of extreme temperature changes with the seasons.
I measured the vee berth and ordered a length of
HyperVent that allowed me to cut and fit utilizing the salvage
edge. In addition to the beneficial air circulation, the
construction of HyperVent makes it an additional cushion under
my bed. I am extremely pleased with the total environmental
impact. The problem of condensation under the sleeping area is
totally gone. There is no longer any compromise of air
quality. My experience with this system is so much better than
with other products I've tried. I can enthusiastically
recommend HyperVent
Home | Products | Press | Testimonials|
Order Now | Contact
| 
